Helpful Tips

How To Clean A Shower Head And Why You Should

Friday 6th October 2017

It's not just neat-freaks who need to know how to clean a shower head: everyone should make a point to do this at least once a season for the sake of their health and their plumbing.

How to Clean a Shower Head

A nice, long shower is a great place to relax or even come up with some of your most creative ideas. But if you haven't cleaned your shower head lately you're not getting nearly as clean as you think.

Dirty shower heads are health hazards

One third of shower heads tested by researchers were found to contain a bacteria associated with pulmonary disease.

Dirty shower heads are also associated with the spread of Legionnaires disease. As if we didn't already have enough to clean, right?

Fortunately, cleaning your shower head isn't difficult. The payoff isn't simply a healthier bathing environment, though: you'll also get a better, stronger spray of water! Here's how to clean yours.

Start with a Deep Cleaning

If it's been a while since you last cleaned your shower head, or if you've never cleaned it at all, start with a deep cleaning.

1. Combine 3 cups of very hot water and 1 cup of white vinegar in a large bowl.

2. Remove your shower head completely and shake out any excess water.

3. Put the shower head in the vinegar water and let it sit for 30 minutes.

4. Use an old toothbrush or bottle brush to scrub the shower head inside and out.

5. Swirl to dislodge additional gunk and allow the shower head to sit an additional 5-10 minutes.

6. Give it one more scrub, drain the water, and rinse the shower head well.

7. Let the shower head fully air dry before reinstalling it. (Now is a good time to use the brush on the shower pipe's threads to remove any buildup there, too.)

Do Monthly maintenance cleaning

Once you've deep-cleaned your shower head you don't need to remove it again unless you see significant buildup. Make it a point to spray it monthly with a vinegar-based cleaning solution (this daily shower spray works) and scrub the spray nozzles to dislodge residue and bio-film. Run the shower to rinse the spray head and you're done.

Or, if your shower head tends to acquire a lot of stubborn buildup due to hard water, you can soak it in place to loosen the gunk before scrubbing. Just combine equal parts white vinegar and hot water in a plastic bag then attach it to your shower head with a rubber band. Let that sit in place an hour, or even overnight, and scrub it with a brush to get it clean again.